A new door is only as good as its installation. We fit the track, hardware, and opener to work together from day one.
Installing a new garage door involves more than setting a panel into an opening. The track has to be plumb, the springs have to be sized for the door's exact weight, and the opener has to be set to travel limits that match the new door's height and thickness. Getting any one of these wrong shortens the life of the whole system, so we treat installation as a full setup rather than a quick swap.
Before installation day, we confirm the rough opening size, headroom, and side room available, since these measurements determine which door styles and track configurations will actually fit your garage. This step avoids the common problem of a door arriving that technically fits the opening but cannot clear an overhead obstruction or a narrow side wall.
During installation, every hinge, roller, and track bracket is set and checked for square before the springs are tensioned. A door that goes in slightly out of square will bind against the weatherstripping, wear rollers unevenly, and put uneven load on the opener over time. We take the extra time at this stage because it is far cheaper to correct than a callback months later.
Once the door is hung, we balance the springs so the door holds its position when disconnected from the opener, the way a properly installed door should. Only after that balance test do we connect and calibrate the opener, then run the door through a full set of cycles to confirm smooth, quiet operation.
Most single door installations are completed in a single day, though the exact time depends on whether the existing track and opener are being reused or replaced as well.
Not always. If your existing opener is in good condition and has enough lifting force for the new door's weight, it can often be reused. We check this during the initial measurement visit.
We need the width and height of the opening, the available headroom above it, and the side room on both sides, since these determine which track and spring configuration will fit.
Call Gulliver Garage Door Services in Wenham, MA and speak with a technician about your garage door installation needs.
Call 1 (833) 652-7571